Enviro EF3 Manuel d'utilisateur télécharger pdf (Page 33)

Troubleshooting

10. The stove will not shut off.

General:

● If the unit will not shut off, ensure that the thermostat (if equipped) is turned down below the room

temperature (thermostat mode in the ON / OFF position).

● Disconnect one of the brown wires from the exhaust temperature sensor. If the unit continues to

operate, contact your local dealer for service.

Circuit Board:

□ If the unit is in the HI/LOW mode the unit will not shut off but will go to an idle setting (LOW). Press

the ON/OFF button to turn the unit off.

Timer Control:

◊ Check the connections to the 140°F (60°C) temperature sensor, start-up switch and the start-up timer

against the wiring diagram.

◊ Check the 140°F (60°C) temperature sensor by removing one of the brown wires from the sensor.

The unit should shut down right away as long as the start button was not pressed within 15 minutes

of this test. If the stove shuts down within fifteen (15) minutes, replace the 140°F (60°C) sensor. If

the stove does not shut down within fifteen (15) minutes, test the switch.

◊ To test the switch, the stove must be cold. Pull the plug, then plug the stove back in. If it fails to start,

replace the switch.

11. The stove keeps going out

If the stove goes out and leaves fresh unburned pellets or cigarette-like ashes in the burn pot liner, the

fire is going out before the stove shuts off.

General:

● Check to see that the Slider / Damper is in the correct position.

Circuit Board

□ Turn the Heat Level up slightly (poor quality pellets will require slightly higher settings).

□ Set the auger trim till the #1 and #5 lights are illuminated.

Timer Control:

◊ Turn the Dial-a-Fire up slightly (poor quality pellets will require slightly higher settings).

If the stove goes out and there are partially burned pellets left in the burn pot liner, the stove has shut

down due to a lack of air, exhaust temperature, or power failure.

General:

● Adjust the Slider / Damper.

● Check to see if the stove needs a more complete cleaning.

● Did the power go out?

● Contact your local Dealer for service.

Circuit Board:

□ Turn the Heat Level up slightly (poor quality pellets will require slightly higher settings).

Timer Control:

◊ Turn the Dial-a-Fire up slightly (poor quality pellets will require slightly higher settings).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 42 43

Pas de commentaire

Enviro EF3 Manuel d'utilisateur Page 33