Enviro EF3 Manuel d'utilisateur télécharger pdf (Page 8)

Routine Cleaning and Maintenance

NOTE: Do not use abrasive cleaners to clean the surface or any part of the stove.

The following should be inspected periodically to ensure that the appliance is operating at its optimum

and giving you excellent heat value:

2-3 Days / Weekly Bi-Annually or 2 Tons of Fuel

Burn Pot and Liner Exhaust Vent

Ash Pan Fresh air Intake Tube

Inside Firebox Blower Mechanisms

Door Glass Heat exchanger tubes

Heat exchanger tubes Behind firebox liners

Ash pan & Door gaskets All Hinges

Door Latch Post Season Clean-up

BURN POT AND LINER (2-3 days)

This is the ‘pot’ where the pellets are burned. The burn pot and liner should be inspected every two to

three days, to ensure proper air flow through the liner. Failure to keep the liner clean may cause

a build up of fuel past the burn pot liner and up the drop tube. This will cause the auger to

jam and may result in pellets burning in the drop tube and hopper.

Ensure the unit is cold before cleaning. To remove the burn pot and burn pot liner, open the door using

the door handle provided, located on the left-hand side of the stove. Swing the door open. Lift the

liner from the burn pot. Lift the burn pot from the firebox by gently lifting the front of the burn pot up

first, then sliding the assembly from the air intake tube and the ignitor cartridge. Using a metal scraper,

remove material that has accumulated or is clogging the liner’s holes. Then dispose of the scrapped ashes

from the liner and from inside the burn pot. Place the burn pot back into the stove, making sure that the

pipes are properly inserted into the burn pot and the front tabs are placed in the firebox. Place the liner

back into the burn-pot making sure that the ignitor hole in the liner is aligned with the ignitor tube. Push

the liner up against the ignitor tube.

● If, after long periods of burning, the fire continually

builds up and overflows the burn pot or there is a build up

of clinkers, this is an indication that the pellet fuel quality

is poor or the stove may need cleaning. Check the stove

for ash build up (clean if required) and adjust the slider /

damper to produce the proper clean combustion.

INSIDE FIREBOX (weekly)

For bi-weekly clean out, ash may be removed from behind the steel plates by rotating the circular cover

to allow vacuuming behind the plates.

ASH PAN AND DOOR GASKETS (weekly)

After extended use the gasket may come loose. To repair or replace this, glue the gasket on, using high-

temperature fiberglass gasket glue available from your local ENVIRO dealer. This is important to maintain

an airtight assembly.

Burn pot

liner

Fresh air

tube

Ignitor

tube

Burn

pot

TOOLS REQUIRED TO CLEAN UNIT

• Torx T-20 Screwdriver

•

/16” Wrench or Socket,

• Brush,

• Soft Cloth

• Vacuum with fine filter bag

The following list of components should be

inspected and maintained routinely to ensure

that the appliance is operating at its optimum

and giving you excellent heat value:

Figure 4: Burn pot with liner.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Enviro EF3 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Four Enviro EF3