Enviro C-11112 Manuel d'utilisateur Page 11
- Page / 14
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
11
ASH PAN AND DOOR GASKETS (weekly)
After extended use the gasketing may come loose. To repair this, glue the gasketing on using high-
temperature fiberglass gasket glue available from your local ENVIRO dealer. This is important to maintain
an airtight assembly.
ASH PAN (weekly)
The ash pan is located under the ash shelf. To remove the ash pan, simply turn the latch with a large
standard blade screwdriver and pull out towards the front. Dump the ashes into a metal container stored
away from combustibles. Monitor the ash level every week. Remember that different pellet fuels will
have different ash contents. Ash content is a good indication of fuel efficiency and quality. Refer to
“INTRODUCTION - SAFETY WARNINGS AND RECOMMENDATIONS” for disposal of ashes. It is important to latch the
ashpan tightly whe re-installing it.
DO NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.
HEAT EXCHANGER TUBES (weekly)
Open the cast front and the rod is located under the unit top, in the center of the stove just above the
door. This handle is to be pulled out a few times (ONLY WHEN THE UNIT IS COLD) in order to clean
away any fly ash that may have collected on the heat exchanger tubes. As different types of pellets
produce different amounts of ash, cleaning of the tubes should be done on a regular basis to enable the
unit to run efficiently.
FRESH AIR INTAKE (season)
Inspect periodically to be sure that it is not clogged with any foreign materials.
EXHAUST PASSAGES (season)
Removal of the firebox backing for bi-annual cleaning (refer to Figure 6):
Routine Cleaning and Maintenance
• Open the door by lifting the handle.
• Remove the burn pot and burn pot liner.
• Lubricate all screws with penetrating oil.
• Remove the four (4) screws that hold
the brick liner retainers in place. Remove
side brick liners by sliding them forward
then out.
• Pull the center panel out.
• Vacuum and clean thoroughly.
Installation of firebox backing:
• Insert center panel with backing.
• Place the two (2) side panels back into
the firebox and reinstall the two (2)
retainers using two (2) screws on each
side.
• Replace the burn pot and burn pot liner
• Close the glass door and secure.
Figure 6: Firebox Components Removal.
Produits connexes et manuels pour Outils Enviro C-11112
Outils Enviro EG40-071 Manuel d'utilisateur
(23 pages)
(23 pages)
Outils Enviro C-11089 Manuel d'utilisateur
(44 pages)
(44 pages)
Outils Enviro C-10985 Manuel d'utilisateur
(31 pages)
(31 pages)
Outils Enviro 50-1220 Manuel d'utilisateur
(14 pages)
(14 pages)
Outils Enviro 50-1574 Manuel d'utilisateur
(30 pages)
(30 pages)
Outils Enviro EP3 Manuel d'utilisateur
(14 pages)
(14 pages)
Outils Enviro 50-1386 Manuel d'utilisateur
(23 pages)
(23 pages)
Outils Enviro C-11256 Manuel d'utilisateur
(16 pages)
(16 pages)
Outils Enviro C-10365 Manuel d'utilisateur
(33 pages)
(33 pages)
Outils Enviro C-10969 Manuel d'utilisateur
(12 pages)
(12 pages)
Outils Enviro 50-1221 Manuel d'utilisateur
(34 pages)
(34 pages)
Outils Enviro C-11114 Manuel d'utilisateur
(13 pages)
(13 pages)
Husqvarna 545RXT Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Gartengeräte Husqvarna 545RXT.
Wir stellen 1 PDF-Handbücher Husqvarna 545RXT zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Commentaires sur ces manuels